13
V01.00 | 2018/08
BOOTP/DHCP Mode (300/400)
■
Assigns an IP address using the BOOTP/DHCP server respectively.
After an IP address is assigned, it is temporarily stored in the device. In order to permanently
store the IP address, set the rotary switches to either:
■
001-253 which affects the last octet of the device IP address
■
500 programmable position
Then cycle power to the device.
PGM Mode (500)
Launch the Turck Service Tool
Select F5 – search network
Under “Mode” verify the device reads PGM
Select F2 – change IP address
Enter desired value
Click “Set in device”
To Next Page
Loading...
