Page 44 of 77
12 CHECKING AND CHANGING PARAMETERS AND OTHER DATA
The control system prevents changing programs if the door is closed. This
protection is intended to avoid program changes if the autoclave is loaded. If the
operator for example inserts the load into the chamber, closes the door and
leaves the room and another operator/user tries to change the program, the
operator/user will not be able to do this unless the door is opened and the load
inside the chamber can be seen.
12.1 Directories and subdirectories
The operator (Admin) may perform the following:
DIRECTORY SUBDIRECTORY
only for Custom programs
See sec. 7.4 “Cycle Parameters (Custom
Program)”
System Parameters
Print Rate All
Print Rate Sterilization
Screen Saver
History
View old cycle history
Export history to USB
Clear history files
Maintenance
Set date and time
Export gain offset to USB
Reset atmosphqaeric pressure
Printer test
Print all gain and offset
Advanced options
Start cycle by clock
Export all settings to USB device
Version information
View current version information
View factory default version information
View previous version information
To Next Page