How to fix a Tuttnauer 3870EA chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer 3870EA Laboratory Equipment?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 3870EA Laboratory Equipment?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer 3870EA Laboratory Equipment printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Inspect the autoclave upon arrival for any shipping damage.
Details the functions of each key on the control panel and program selection.
Details error messages, warnings, and safety precautions displayed by the unit.
Instructions and parameters for sterilizing unwrapped instruments.
Parameters and procedure for sterilizing wrapped items and porous loads.
Specific program settings for sterilizing glassware.
Guidelines for electrical connection and safety precautions.
Safety instructions for moving the autoclave.
Pre-sterilization cleaning and preparation of instruments.
Use of indicators and spore tests for sterilization assurance.
Steps for initial operation and setup before first use.
Overview of routine maintenance tasks to keep the autoclave in good working order.
Solutions for when the autoclave does not power on or respond.
Troubleshooting steps for the 'Low Heat' error message.
Solutions for the 'Low Water' error message.
Troubleshooting steps for the 'Low Pressure' error message.
Solutions for the 'Low Temperature' error message.
Troubleshooting steps for the 'High Temperature' error message.
Solutions for the 'High Pressure' error message.
Solutions for leaks occurring at the autoclave door.
Steps to clear a clogged drain in the autoclave.
Troubleshooting issues with sterilization indicators.
Solutions for wrapped items not drying properly.
General| Frequency | 50/60 Hz |
|---|---|
| Power Supply | 120V or 230V |
| Temperature Range | 105°C to 137°C |
| Control System | Microprocessor control |
| Trays Capacity | 3 |
| Voltage | 220-240 V |
| Operating Temperature | 5°C to 40°C |
| Chamber Volume | 85 liters |
To Next Page
