Need help?Do you have a question about the TVC Ethos Two and is the answer not in the manual?
General| Brand | TVC |
|---|---|
| Model | Ethos Two |
| Category | Controller |
| Language | English |
Guide for installation, servicing, and fault finding of Ethos Two control panel.
Covers main variants of Ethos Two controller and key ancillaries.
Lists abbreviations and their meanings used in the manual.
Warns about lethal voltages and handling electronic devices.
Provides contact information for Thames Valley Controls.
Explains the Ethos Two Lift Control System, its modules, and communication protocols.
Highlights modularity, touch screen interface, ride sensor, event logger, and automated features.
Details the technical specifications of the main controller, including CPU and features.
Specifies operating and storage conditions for the controller.
Lists relevant BS EN standards the controller meets.
Mentions availability of EMC and Safety compliance certificates.
Describes software tools for fault finding like Solutions and Event Logger.
Details configuration switches and layout for Main CPU, MMI, and ETSD Card.
Explains the meaning of different colored buttons on the MMI interface.
Procedure to calibrate the MMI touch screen if inaccurate.
Describes various operating modes like Normal, Door Disable, and Inspection Control.
Explains different call collection options like Full Collective, Down Collective, etc.
Explains configuration for simplex, dispatcher-less, and HCD groups.
Details parameters for door dwell, operation, and protection.
Covers settings for indicators, speech, lanterns, and gongs.
Brief descriptions of features like Accelerometer, Auto Recovery, Eco Mode, etc.
Explains how to check features like Final Limit Monitor, Safety Gear Monitor, etc.
Details checks for brake lift, dual valve, and iCON SMA valve tests.
Explains the Solutions button and its display of active events.
Describes the event logger's function, categories, and data recorded.
Explains the I/O trace facility for tracking intermittent faults.
Guides on adjusting and saving/restoring parameter sets via the MMI.
Warns about removing the SD card and its impact on logger/settings.
Step-by-step guide to modify parameters using a PC and JSON file.
Instructions for upgrading firmware on lift and display boards using an SD card.
Procedure for upgrading the ETSD card software using an SD card.
Describes available 8-way and 16-way call modules and serial landing network.
Lists available feature modules (input/output) for interfacing with BMS or hall lanterns.
Step-by-step guide for installing the panel and commissioning the lift.
Describes various tests like Auto Run, Activate Service, Brake Test, and UCM testing.
Precautions specific to traction lift installation, including autotune and rotation check.
Introduces the E300 regulator modes and drive characteristics.
Provides a step-by-step sequence for installing and commissioning traction lifts.
Introduces hydraulic setups controlled by Ethos Two.
Step-by-step guide for installing and commissioning hydraulic lifts.
To Next Page
