TVC Ethos Two - 4.8. Motion Feature Checks

Page 22 of 102
TVL 351
ISSUE 15
Rope Brake Monitor
This activates an input that monitors the rope brake, once tripped the lift will shut down and not move until the input
is restored and the event reset in the solutions menu.
Inputs: "RBM ", "Rope Brake Monitor"
Test Up Limit Monitor
This feature checks the test up limit on normal when at the top floor, if the limit is not seen, the controller will not
allow movement on inspection or emergency electrical operation. This event can be reset in the solutions menu,
only when on inspection or emergency electrical operation.
Inputs: "TUL ", "Test Up Limit"
4.8. Motion Feature Checks
Depending on the lift type the following features can be enabled, these features require additional external circuitry
so need to be requested at panel build time.
Press: Settings → Search Settings → Brake → Brake Lift Confirm
Brake Lift Confirm
Brake lift confirmation checks that the brake operation is correct during a lift journey by monitoring a confirmation
output from the brake.
Inputs: "BLC1 ", "Brake Lift Confirm 1" + "BLC2 ", "Brake Lift Confirm 2" + "BLC3 ", "Brake Lift Confirm 3"
Press: Settings → Search Settings → Valve Checking
Dual Valve Test
Dual Valve Test performs a once daily check that the lift does not move if only one valve is active on a dual valve
setup. The lift is first returned to the lowest floor then tested. If the lift does move, during the test, the lift will be
shutdown. This event can be reset in the solutions menu.
Outputs: "VR1 ", " Valve Release Output 1" + "VR2 ", " Valve Release Output 2"
Valve Test
Valve test confirmation checks that the hydraulic valve operation is correct during a lift journey by monitoring a
confirmation output from the valve block.
Inputs: "VC1 ", "Valve Confirmation Ip 1" + "VC2 ", "Valve Confirmation Ip 2"
iCON SMA Valve Test
iCON valve test confirmation checks that the hydraulic valve operation is correct during a lift journey by monitoring a
confirmation output from the valve block.
Inputs: "SMA ", "iCON SMA Monitor Input"