Page 102 of 102
TVL 351
ISSUE 15
Document Change Log
Issue Date Section / Page Software
Version
1.0 23/05/2017 All - First Issue CSV2.06
2.0 22/08/2017 Install Guidelines, Events, Autotune, Initial Site Req.
CSV2.07
3.0 10/10/2017 Static Autotune, Events, Program Proc.
CSV3.00
4.0 17/01/2018 Added buffer test, Drive timer description. UCM A3 Testing.
CSV3.04
5.0 03/05/2018 Added Temperature Events, MB SI4-7 now only take 110V
CSV3.06
6.0 16/08/2018
Autotune Gearless and Geared. Hydraulic shaft learn. Software
Modification Procedure.
CSV4.00
7.0 30/11/2018
Checklist order, ETSD Test, Group CAN baud. Buffer and
Overspeed tests added to MMI
CSV4.01
8.0 27/06/2019
Speed deviation, Limit checks on learn, E300 Open Loop, PIT
input, Recall Floors Screen.
CSV4.04
9.0 05/11/19
A3 relevel tests. Drive Troubleshooting. Stopped Off Level Events.
HW02 Sheets.
CSV4.05
10.0 11/06/2020 Added Hydraulic Levelling Setup and link for Static tune
CSV4.05
11.0 16/06/2021 Autotune log clear, IoT events.
CSV4.08
12.0 28/02/2022
Limax3CP Appendix and Checklist items, New 4IO module, New
HW03.
CSV6.00
13.0 10/06/2022 Updates to Limax and E300 Drive start timing.
CSV6.00
14.0 12/10/2022
Text Corrections, Magnetic DZ Distance, Limax3CP Shorting Link
Table.
CSV6.01
15.0 11/11/2022 Additions to Limax3CP Shorting Link Table.
CSV6.02
Thames Valley Controls owns the copyright of this document which shall not be used for any purpose other than for which it is supplied and
shall not be copied or given to any person or organization without written authorisation from the owner.
To Previous Page
Loading...
