Tyco kENDALL KANGAROO ePump - Page 16

ENG15
Description Code Probable Causes of Failure Min Max Input Units Output Units
BatVADC 26 If too low then weak or damaged battery or battery cable unplugged or
open circuit, if too high then possible circuit board problem 154 253 Counts Voltage (V)
BatTADC 27 If too low (cold) then battery cable is unplugged or open circuit, if too high
(hot) then battery thermistor short circuit, replace battery 37 180 Counts Temperature (C)
RotorPreCut 28 If very low, motor or motor cable open circuit or insucient gearbox
lubrication; if too high gearbox may be locked up 18 105 Current (mA) Current (mA)
RotorPostCut 29 If too low, insucient gearbox lubrication; if too high, obstruction at
rotor after the “Cut Tube” step or excessive gearbox friction 5 75 Current (mA) Current (mA)
NoLoadRotorRPM 31 If too low, obstruction at rotor after the “Cut Tube” step or excessive
gearbox friction; if too high, insucient gearbox lubrication 32 46 RPM RPM
6VCurRangeNoTube 32 N/A 0 255 Counts Counts
6VCurRangeTube 33 N/A 0 255 Counts Counts
14VCurRangeNoTube 34 N/A 0 255 Counts Counts
14VCurRangeTube 35 N/A 0 255 Counts Counts
TBD1 36 N/A 0 255 Counts Counts
TBD2 37 N/A 0 255 Counts Counts
TBD3 38 N/A 0 255 Counts Counts
An item marked N/A may show up as a failure, but the root cause of the failure is always some other
“N/A” means that the calibration cannot fail for this item alone.