Tyco kENDALL KANGAROO ePump - Specifications

ENG5
Specications and Symbols
Specications
UL Listing Medical Electrical Equipment
KANGAROO ePump™ Enteral Feeding Pump
(1) Classied with respect to electrical shock, re, and mechanical hazards in accordance with UL60601-1.
(2) Classied with respect to electrical shock, re, mechanical and other specied hazards in accordance with CAN/CSA C22.2 No. 601.1
Type Infusion Device Volumetric
Pumping Mechanism Rotary Peristaltic
Pump Sets KANGAROO ePump MISTIC Feed-Only Set or Feed & Flush Set
Feeding Formula Delivery Rate 1-400 mL/hr in 1 mL increments
Feeding Formula VTBD 1-3000 mL in 1 mL increments
Bolus Volume 1-3000 mL in 1 mL increments
Number of Boluses 1-99
Bolus Interval 1-24 hours in 1-hour increments
Flushing Solution Dose Range 10-500 mL in 1 mL increments
Flushing Solution Interval Range 1-24 hr in 1 hr increments
Accuracy ±10% or 0.5 mL/hr, whichever is larger, with bottom of bag at 46 cm (18”) above the top of the pump, at room temperature 22° C ± 2° C
(72° F ± 3° F), using a new pump set.
Occlusion Pressure 15 psi (103 kPa) Nominal
Dimensions Height: 16.8 cm (6.6”) Width: 16.3 cm (6.4”) Depth: 11.7 cm (4.6”)
Weight 1.1 kg (2.4 lbs), 1.2 kg (2.7 lbs) with pole clamp
Material Housing: ABS/Polycarbonate blend
Pump Set Door: Polyester/ Polycarbonate blend
Power Use AC adapter for wall outlet usage. Pump operates on 9V DC, 1.5 Amps.
Battery New, fully charged NiMH Battery Pack delivers ≥ 15 hrs at 125 mL/hr feed rate.
Approximately 15 minutes prior to complete battery discharge, a low battery alarm will occur (see subsection “Battery Low” in Section
VI). When complete discharge occurs, the pump will automatically turn itself o. The battery will charge continuously whenever the
pump is plugged into a wall outlet. Eight hours of charging is required to fully recharge the battery pack.
Alarms
System Error
Flow Error
Pump Set Dislodged Error
Hold Error
Rotor Error
Feed Error
Flush Error
Battery Low
Alarm Volume Minimum of 70 dBA at 1 meter in maximum volume orientation
Operating Temperature 10° - 40° C (50° - 104° F) 75% R.H. non-condensing
Storage Temperature 0° - 50° C (32° - 122° F) 95% R.H. non-condensing
Type of Protection Against Electrical Shock Class II, Internally-powered Equipment
Degree of Protection Against Electrical Shock Type BF
Mode of Operation Continuous or programmed intermittent operation
Degree of Protection Against Ingress of Fluids Drip-proof-IPX1