<Checking>
① Checking battery charging level
If the battery is not used for over
two weeks, it may become hard to
start the engine. Charge the bat-
tery in this case.
② If the battery terminal is corroded,
it cannot deliver current. If it is
corroded or contaminated, wipe it
with sandpaper or a brush.
<Charging>
① Turn the ignition switch to the
"OFF" position and remove the
battery from the tractor.
② Charge the battery in a well-
ventilated area.
③ Charge the battery with the nor-
mal procedures and avoid quick
charging.
④ Turn the charger switch OFF and
connect the cables to the nega-
tive and positive battery termi-
nals correctly.
⑤ When using a charger, its charg-
ing current should be below 10 A.
T254O531A
Negative (-)
terminal (black)
Positive (+)
terminal (red)
JUMP START
① Turn off all electric devices.
② Connect the positive terminal of
the normal battery to the positive
terminal of the discharged battery
with the jump cable.
③ Connect the negative terminal
of the normal battery to the en-
gine body of the tractor for the
discharged battery with the jump
cable.
►
T254O532A
Battery specification
12V 80AH (20HR)
To Next Page
Loading...
