REPLACING LAMP BULB
If a lamp does not come on by oper-
ating the corresponding switch:
① Check the corresponding fuse.
②
If the fuse is intact, remove the
bulb socket from the lamp.
③ Remove the bulb from the socket
and check for blown filament.
④
If the filament is blown, replace
the bulb with a new bulb with the
same capacity.
►
Bulb Specifications
Headlamp 1
2V H4 55W
Turn signal lamp (Front) 1
2V 21W
Turn signal lamp (Rear) 1
2V 21W
Position lamp (Front) 1
2V 5W
Stop lamp/position lamp 1
2V 21W / 5W
Instrument cluster lamp 1
2V 3.4W
Work lamp(Rear) 1
2V 25W
To Next Page
Loading...
