typical TW1-2B - Table of Contents

CONTENTS
Operation instructionOperation instruction
Parts manualParts manual
1. Brief introduction
2. Main technical specification
3. Operation and preparation
4. Installing the clutch motor
5. Connecting the clutch motor lever to the pedal
6. Connecting the presser foot lift control pedal
7. Installing the belt guard
8. Installing the bobbin winder
9. Lubrication
10. Trail run
11. Installing the needle
12. Coordination among the needle, the thread and the material
13. Threading the needle thread
14. Winding adjusting
15. Adjusting the forward stitch length and reverse stitch length
16. Oiling the thread take-up part
17. Adjusting the pressure of presser foot
18. Installing the bobbin and adjusting the thread tension
19. Adjusting the thread take-up spring
20. Adjusting the tension of needle thread and bobbin thread
21. Timing between he needle and the rotating hook
22. Installing and uninstalling the hook
23. Installing the hook stop bracket
24. Installing the Feed dog
25. Feed timing adjustment
26. Upper feed adjustment
27. Adjusting the clearance between presser foot and walking foot
28. Periodical cleaning
1. Arm and bed
2. Thread take-up mechanism
3. Bottom feed mechanism
4. Presser bar mechanism
5. Upper feed mechanism
6. Accessories
1. Brief introduction
2.
Main technical specification
3.
Operation and preparation
4.
Installing the clutch motor
5.
Connecting the clutch motor lever to the pedal
6.
Connecting the presser foot lift control pedal
7.
Installing the belt guard
8.
Installing the bobbin winder
9.
Lubrication
10. Trail
run
11.
Installing the needle
12.
Coordination among the needle, the thread and the material
13. Threading
the needle thread
14. Winding
adjusting
15. Adjusting
the forward stitch length and reverse stitch length
16.
Oiling the thread take-up part
17. Adjusting
the pressure of presser foot
18.
Installing the bobbin and adjusting the thread tension
19. Adjusting
the thread take-up spring
20. Adjusting
the tension of needle thread and bobbin thread
21. Timing
between he needle and the rotating hook
22.
Installing and uninstalling the hook
23.
Installing the hook stop bracket
24.
Installing the Feed dog
25.
Feed timing adjustment
26.
Upper feed adjustment
27. Adjusting
the clearance between presser foot and walking foot
28.
Periodical cleaning
1. Arm
and bed
2. Thread
take-up mechanism
3.
Bottom feed mechanism
4.
Presser bar mechanism
5.
Upper feed mechanism
6. Accessories
1
1
1
1
2
2
2
3
3
4
4
4
5
5
5
6
6
6
7
7
8
9
9
9
10
11
11
11
12-13
14-15
16-17
18-19
20-21
22-23