8
Power supply and battery charging cable
Figure 3 - Power supply connector
Charging the Minisonic II
Plug the charger into a 100-240V ac 50/60 Hz mains supply, then insert the plug in the power supply connector. The green
«Charging» LED should come on. It goes out when charging is complete.
You can check the device’s charging progress on the information screen.
Important:
Using a power supply dierent from the one supplied with the device is not covered by the Ultraflux guarantee.
Battery pack service life
The battery pack service life depends on the number of charge/discharge cycles. The service life may be shortened by in-
correct use or maintenance. For example, if the batteries are left discharged for a long period of time or are subjected to
incomplete charge/discharge cycles.
The battery pack can be replaced. Although this is expected and easy to do, nevertheless it must be done in our workshops
for it to be covered by our guarantee.
We cannot be held responsible for any unauthorized operation.
To Next Page
Loading...
Need help?
General
