23
Configuration menus
Measurement config.
Configuring all the characteristics of a measuring point.
In this menu you will set up the device, so that it works for a specific application: Characteristics
of the pipe / Characteristics of the fluid / Characteristics of the probes used.
(See detail)
Probe distance
Tells you what distance to allow between the probes, according to the data entered in
«Measurement Configuration» (See details)
US Signal display
Allows you to see the nature and quality of the measurement echo. This is a determining factor
in the analysis of measurement conditions and allows you to identify any configuration error (pipe
diameter or thickness, etc.)
(See details)
Auto zero
Gives you the ability to refine the device’s response under strict conditions
of «Pipe full + No flow» (See details)
Advanced meas.
Provides access to the details of a number of measurements that could guide you in your search
for better performance
Device configuration
Adjusting information
Chapter selection
Confirms the entry in the chapter in «reverse video»
Return to previous chapter
Return to measuring screen.
To Next Page
Loading...
Need help?
General
