To Check Product Counts: press and hold the P key for
3 seconds. COUNTS will be displayed.
Press the P key. global will be displayed then the total number
of cook counts will be shown.
Press the P key. FILTRCNT will be displayed then your total
filter count will be shown.
Press the P key. DISPCNT will be displayed then your total
disposal count will be displayed.
Press the P key. TOTALX10 will be displayed then your total x
10 global count will be shown. Then press the P key.
To Exit Product Counts: COUNTS will be displayed. Press
the up arrow key. EXIT will be displayed. Press the P key. The
controller will exit programming mode.
When filtering is performed, the oil must be dumped from the
vat for 3 minutes. The filter countdown will then begin at 7
minutes, at which time the Polish should be performed. At the
end of polishing operation, the display will show FILL. Return
the oil to the vat.
Press the ENTER/EXIT FILTER key to clear the message and
go into an idle state. The oil will be heated to the correct pre-
programmed temperature.
To Force A Filter at any time of the day: press and hold
the SCAN and ENTER/EXIT FILTER keys at the same time
for 3 seconds. ILTER will be displayed and an alarm will be
heard.
Press the ENTER/EXIT FILTER key to start the filtering se-
quence.
8 30A216 REV A Oct 2009
Operating the
Controller
CONTINUED
Product Counts
Filter / Polish
Force A Filter
To Next Page
Loading...
Need help?
General