Ulvac DPG-30R - Page 20

DC Power Supply [DPG-30R & DPG-MC60R, DPG-MC120R, DPG-MC240R]
2. Overview
10
*2
changes by the number of power supplies.see Table 4-1
*3
changes by the number of power supplies.see Table 4-1
*4
During P control:becomes the corresponding system power for a output setting voltage level 0 to 10 V
During I control: becomes the corresponding system power for a output setting voltage level 0 to 10 V
During V control: becomes the corresponding system power for a output setting voltage level 0 to 10 V
See Table 4-2
*5
HARC in an AD-IF connector and a MARC signal take out the pulse signal of the LOW level during 20 ms at the time of
ARC detection.
*6
Effective only at the time of Remote Mode. Necessity of resetting from the controller front panel, at the Local Mode.See
the Table 3-2