Table 2-11 Pulse width Trigger
The system automatically acquires waveform data when there is
no trigger signal. The scan baseline is shown on the
display. When the trigger signal is generated, it automatically
The system stops acquiring data when there is no trigger signal.
When the trigger signal is generated, trigger scan occurs
One trigger will occur when there is an input trigger signal. Then
Set the positive pulse width as the trigger signal
Set the negative pulse width as the trigger signal
Trigger occurs when pulse width of the input signal is smaller
Trigger occurs when pulse width of the input signal is larger than
Trigger occurs when pulse width of the input signal equals to the
To Next Page
Loading...
