Unicum NERO - Page 37

User manual for NERO / NERO INSTANT
Page 34Version 3.2 / December 2017
ТМ
Sub-menu Description Value
1.1.16 EVA settings Parameters of statistical data
1.1.16.1 Reset interim Data Reset temporary data after saving (copying) of les to USB
drive
Yes / No
1.1.16.2 Switch lds If set to YES, the output (conguration and audit) les will carry
the Machine number set in 1.1.2 instead of the Machine’s serial
number
Yes / No
1.1.16.3
Load CONF_GEN only
- NO enables loading all les from USB;
- YES enables loading only CONF_GEN extension les
Yes / No
1.1.16.4 Enable USB prices Allow/prohibit change of prices using a USB drive Yes / No
1.1.16.5 Audit le version Selecting the version of EVA-DTS le 6.0
6.1
1.1.17 Header message
Header caption, which is displayed on the LCD Line entry
1.1.18 LAN Internet access conguration No
Yes - to sub-
menu
1.1.18.1 Local MAC Allow/restrict the use of MAC address No
Yes - to sub-
menu
1.1.18.1.1 Local MAC Setting MAC address.
The MAC address is set using the menu.
It can comprise of any values with only two limitations:
1) The rst digit must be less than 8 (best practice is to set it
to 0). If the rst character will be 8…F the Machine cannot go
online.
2) Within the LAN to which the Machine is connected, the given
MAC address must be unique.
Violation of this requirement can cause the LAN to malfunction
Enter
12 characters
0...F
1.1.18.2 IP address
Setting IP address for the Machine.
This displays the internal IP, assigned by the network admin-
istrator.
Within the LAN this address must be unique. The leading part
of the address (which is determined by the subnet-mask, see
below) must be the same as the leading part of addresses of
all connected devices.
12 characters