Unicum NERO - Page 68

User manual for NERO / NERO INSTANT
Page 65Version 3.2 / December 2017
ТМ
• General conguration: File format EVA-DTS. File name: CONF_GEN.DTS. The le can be downloaded
to the machine with any number specied in clause 1.1.2.
It is necessary to insert the USD-ash drive into the USB connector to access the information on the
drive. The USD connector is situated on the inner side of the vending machine’s door (see section 3.5.13).
This connection should be made when the machine is in selling mode and when asked conrm the follow-
ing: “Load Gen. Cong.?”
• Software update: to update the machine’s software, you must visit the manufacturer’s website at http://
www.unicum.ru/en , go to DOCUMENTATION section and select the relevant vending machine model
on the resulting page to update the software. On the resulting page select FIRMWARE UPDATE, which
will lead to automatic downloading of les to your computer. The les are downloaded in an archive.
To copy the les to the USB-ash drive unpack the archive and save the contents of the le to the root
directory of the USB-ash drive. The archive contains software update les and les with installation
instructions.
To update the software on the machine, it is necessary to insert the USB drive with copied les into the
USB connector, which is situated on the inner side of the machine’s door (see section 3.5.13). After the
recognition of les (validation) the machine’s display shows option to update machine’s software.
To download the power board must approve the request: ‘‘Load Hot Firmware?’’
To download the software of the main board machine must approve the request:
‘‘Load Firmware?’’
Editing conguration les, and view audit les by using a special program ‘‘Unicum Vending Machine
Tools, which can be downloaded here:
https://uonline.unicum.ru/ef/tools/uVMTools.msi