At 'Set Level' scroll to:
Auto- the scanner automatically sets the emergency alert beep to the master volume level. Press E/yes to save and exit.
Level 1-15- scroll to the volume level preferred. Press E/yes to save and exit.
Set C-Ch Only (Motorola only) allows you to enter just the control channels for a Motorola system. The scanner will then find (but will not program) any active voice
channels and any new voice channels. Tip: Enter all of the frequencies and set the system for C-Ch Only in case the control channels change. The default setting is on.
Scroll to 'Set C-Ch Only' and press E/yes.
Scroll to one of two settings and press E/yes to save and exit.
Off- you must enter all voice and control channel frequencies.
On- you only need to enter control channel frequencies.
Contents
EDACS ID Format (no EDACS SCAT) sets how your scanner displays
EDACS IDs. They can be displayed in two formats: AFS and Decimal. The default setting is
AFS.
Scroll to 'EDCS ID Format' and press E/yes.
Scroll to 'AFS Format' or 'Decimal Format' and press E/yes to save and exit.
Rvw ID:Srch L/O allows you to review locked out IDs in a system and unlock them.
Scroll to 'Rvw ID:Srch L/O' and press E/yes.
At 'Unlock?' scroll to the ID and press E/yes to unlock. 'Nothing Locked' appears if nothing is locked out.
Press 'Menu' to return.
Clr All L/O IDs allows you to unlock all the locked IDs in a system.
Scroll to 'Clr All L/O IDs' and press E/yes.
At 'Confirm?' press E/yes to save and exit.
'Nothing Locked' appears if nothing is locked out. Press 'Menu' to return.
Adjusting the P25 Level (Motorola and Conventional only) This setting determines some system-specific parameters for digital channels. In most cases,
setting this to Auto provides the best performance. However, you can also
manually set the digital decode threshold. This setting affects all digital channels in the current
system.
See also
Adjusting P25 Wait Time and Optimizing P25 Performance.
Scroll to 'Adjust p25 Level' and press E/yes.
Scroll to one of three settings and press E/yes to save and exit.
Auto- the scanner automatically adjusts the digital decode threshold to match the transmission you are hearing when it receives a strong signal and has a high
decode rate.
Manual- lets you manually adjust the digital decode threshold.
Default- sets the digital decode threshold to the default value. This is handy if you have manually adjusted the value to a setting that prevents proper decoding.
Creating Groups
Contents
Once you have your
Systems Created and your Systems Options configured you can create your groups.
To Next Page
Loading...
Need help?
General