Scroll to Set Step and press E/yes. See also
Auto Step Sizes.
Scroll to Auto, 5, 6.25, 7.5, 8.33, 10, 12.5, 15, 20, 25, 50, or 100 to set the step size and press E/yes.
Scroll to Set C-Ch only and press E/yes. (for Motorola and LTR systems).
Scroll to On or Off and press E/yes.
Scroll to Adjust p25 Level and press E/yes.
Scroll to one of three settings and press E/yes.
Auto- the scanner automatically adjusts the digital decode threshold to match the transmission you are hearing when it receives a strong signal and has a
high decode rate.
Manual- lets you manually adjust the digital decode threshold.
Default- sets the digital decode threshold to the default value. This is handy if you have manually adjusted the value to a setting that prevents proper
decoding.
Scroll to Search with Scan and press E/yes.
Scroll to Set Lockout and press E/yes. (For use for with 'Search with Scan').
Scroll to 'Unlocked', 'Temporary L/O', or 'Lockout' and press E/yes to save and exit.
Scroll to Set Hold Time and press E/yes.
Enter the hold time (0-255 seconds) you desire and press E/yes to save and exit. (0 will search the whole band before continuing).
Press Menu to exit.
Press Menu and scroll to another custom search and repeat the previous steps or press L/O to exit.
Custom Search lets you search the scanner's 10 programmed frequency ranges. See Editing a Custom Search first.
Contents
To start a Custom Search, in scan mode Press and hold Func then press Scan/Srch.
At 'Quick Search?' press (.)no.
At 'Search for...' scroll to 'Custom Search' and press E/yes to start searching. Then see
Searching.
Searching (only, not search w/scan)
To start a search see Quick Search, Service Search, or Custom Search.
To toggle search bands on or off (custom search), press the number key of the search band.
To hold on a frequency, press Hold. Press Hold to resume.
To step through the frequencies, turn the scroll. Press Hold to resume.
To change search direction or continue searching, turn the scroll control back or forward.
To step through the frequencies, press Hold. Turn the scroll control back or forward while in hold mode. Press Hold to resume.
To lock out a frequency, press L/O.
To unlock frequencies see
Reviewing Locked Out Frequencies.
To check for a repeater frequency, press Hold to hold on the frequency then press and hold .no(rev). Press Hold to resume.
To attenuate a search, press and hold Func then press E/yes(att).
To save a frequency, press Hold to hold on the frequency then see
Programming Displayed Frequency.
To turn Close Call on or off, press and hold Func then Hold to toggle between
CC Priority, CC DND, and 'CC Off'.
Programming a Displayed Frequency (while searching)
To Next Page
Loading...
Need help?
General