When the scanner detects a Close Call signal, 'CC Found!' and 'Press Any Key' appear for the length of time set in Close Call Pause (or until the signal is lost if longer).
Press any key (except Hold) to display the frequency for the delay time set in
Search/Close Call Options (even if it's gone).
To hold on a CC hit press Hold. Press Hold again to resume. See
Close Call Hold Mode.
To save a frequency press 'Any key' then E/yes then see
Programming a Displayed Frequency.
To cancel a CC hit turn the scroll control.
To lock out the frequency press L/O.
To view the last CC hit press Hold. Press Hold again to resume.
To turn the attenuation on or off (for all bands) press and hold Func then E/yes(att) to toggle on or off.
To exit CC only press Scan.
Notes: The Close Call feature does not work for frequencies greater than 956 MHz.
While scanning or searching with Close Call Override set to On, when the scanner detects a Close Call signal, the scanner overrides the current
audio and goes to the Close Call hit.
'CC Found!' and 'Press Any Key' appear for the length of time set in
Close Call Pause (or until the signal is lost if longer). If you do not press 'Any Key', the scanner
will return to scanning.
Press any key (except Hold) to listen to and display the frequency for the delay time set in
Search/Close Call Options (even if it's gone).
Quickly press Hold to stay on the frequency. Press Hold again to resume.
While scanning or searching with Close Call Override set to Off, when the scanner detects a Close Call signal, the scanner does not override the
current audio.
'CC Found!' and 'E to Listen' appear for the length of time set in
Close Call Pause. If you do not press E/yes, the scanner will return to scanning.
Press E/yes to listen to and display the frequency for the delay time set in
Search/Close Call Options (only if it's still there).
Quickly press Hold to stay on the frequency. Press Hold again to resume.
While in Hold mode:
To save a frequency press E/yes then see
Programming a Displayed Frequency.
To lock out the frequency press L/O.
To start a 'Quick Search' at the current frequency turn the scroll control then press Hold.
To check for a repeater frequency quickly press Hold to hold on the frequency. Press and hold Func then press and hold .no(rev). Press Hold to resume.
Close Call Auto Store
Allows you to automatically store Close Call hits into channels. If you turn this feature on, the scanner mutes, starts Close Call Only mode, and stores any Close Call hits
from the bands selected in '
Set CC Bands' up to the maximum you specified in the 'Max Auto Store' setting. The scanner looks for active frequencies within the range(s)
and 'Search and Store' appears in the display. When the scanner finds an active transmission, it checks to see if the frequency has already been stored in the system.
If the frequency has already been stored, the scanner continues to search. If the frequency has not been stored, it stores the frequency into a (created) system called
'Close Call' and a (created) group named 'Found Channels' then resumes searching. This new system and group have the same options as any conventional system/
group and can be edited the same way.
Scroll to 'CC Auto Store' and press E/yes.
'Limit Reached' will appear in the display when the Max Auto Store value is reached.
Press Scan to exit.
Weather Operation Menu (not w/UBCD396T)
Contents
To Next Page
Loading...
Need help?
General