Scroll to 'Set Tone' and press E/yes.
Notes: For two-tone pages, enter the tones (in Hz) for tone A and tone B.
For one-tone pages using short tones between 1.25 and 3.75 seconds, enter tone for tone A, and 0 for B.
For long-tone pages, such as group pages of more than 3.75 seconds, enter 0 for A and the tone for B.
Scroll to 'Edit Tone A' and press E/yes. Enter the tone and press E/yes to save and exit.
Scroll to 'Edit Tone B' and press E/yes. Enter the tone and press E/yes to save and exit.
Press Menu to return.
Scroll to 'Set Delay Time' and press E/yes.
Scroll to one of 3 settings and press E/yes to save and exit:
Off - the scanner resumes standby as soon as the carrier drops after a page.
1-30 - (seconds): the scanner resumes standby mode after the carrier drops and the selected time expires.
Infinite - you must press Hold after a page to resume standby mode.
Scroll to 'Set Alert' and press E/yes.
At 'Set Tone' scroll to the alert (Alert 1-9 or Off) and press E/yes.
At 'Set Level' scroll to 'Level 1-15 or Auto' (the scanner sets the alert beep to the master volume level) and press E/yes to save and exit:
Scroll to 'Set Record' and press E/yes.
Scroll to On or Off and press E/yes to save and exit.
Press Menu to return then scroll to 'Tone-Out 2' and repeat to program more tones.
Press Menu to return.
Using Tone-Out Standby See Setting up Tone-out first.
Press Menu. Scroll to 'Tone-Out for...' and press E/yes.
Scroll to 'Tone-Out Standby' and press E/yes.
Scroll to monitor a Tone-Out channel (1-10).
Press Scan to exit.
The display will show the tone-out name, channel number (1-
10), and tone settings. Any transmission received on the
frequency will not be heard but you will still see the signal
strength bars.
All tone-outs (channels) that have the same frequency (and
modulation and attenuation) as the one you select will also
(and only) be monitored so you can monitor up to 10 tone-out
channels for one frequency. In this case, the scanner displays
each tone-out channel for two seconds. It does not scan them;
tone-out monitors the frequency for all tone-out channels with
the same frequency. Regardless of the current display, the
scanner will alert on any received tone out that matches a
stored setting (channel) for the frequency.
To monitor a different frequency, scroll to a tone-out (channel)
with a different frequency.
If you press Hold while in standby mode, the scanner
temporarily exits standby and you will be able to hear any
transmissions on that frequency. No alerts sound, even if a
tone-out matches one you have stored in hold mode. Press
Hold again to return to standby mode.
To Next Page
Loading...
Need help?
General