Setting the Dial Mode (Australia Only)
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing; the
default setting is tone dialing. Set the dialing mode to match the dialing system used by your
local phone service.
If you are not sure of your dialing system, make a trial call. If the call connects,
leave the setting as is; otherwise set the unit to pulse dialing.
If your phone system requires pulse dialing and you need to send DTMF tones in
certain situations during a call, you may switch over to tone dialing (refer to "Tone
Dialing Switch-over" on page 34).
1) Press the soft key. Select the Global Setup menu,
and then the Dial Mode submenu.
2) Press to select Tone or Pulse (the
initial setting is Tone).
3) Press the soft key. You will hear a confirmation tone.
!
!
MENU
OK
/volume up/down
BACK OK
Dial Mode
Pulse
Tone
[26]
GETTING STARTED
To Next Page
Loading...
Need help?
General
