Storing Caller ID messages in the Phonebook
STORE
Messages shown in the Caller ID list can be stored in the phonebook. The phone number
and name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, select the Caller ID message to be stored. Then
press the soft key. appears. If the Caller ID message is
already stored in memory, you will hear a beep and
appears. The number will not be stored.
2) To complete the setting, follow the steps 4-8 in "Phonebook (Storing Phone Numbers,
Names, Distinctive Rings, and Speed dial)"on page 38.
Store/Edit Name
This data is already stored!!
[51]
!
!
If the Caller ID
message was
received as a
private/unknown
number, or the
message does not
have the number,
you cannot store
the message in the
Phonebook. If it
was received as
private/unknown
name, the
message will be
stored as <No
Name>.
Even if the 100
memory locations
are full, the
message will be
stored in the
Phonebook.
However, the
message will be
erased from the
Caller ID list.
To Next Page
Loading...
Need help?
General
