!
!
!
!
If the recording
memory is full,
appears
in the display. You can
not record a
conversation until you
clear some messages
from the memory.
Every state has
different regulations
governing the
recording of
conversations over the
telephone.
Make sure to check
your local, state and
federal laws before
using this product to
record any telephone
conversation in order
to determine that your
use is in compliance
with such laws or
guidelines.
You can not record
intercom
conversations.
To activate this feature,
you must turn the Call
Screen feature on. See
“Setting the Call
Screen“ on page 24.
Unavailable
Voice memo (Base Only)
Recording a conversation
Screening a call
The voice memo function allows the user to record messages (more than two seconds and
less than four minutes).
1) With the phone in standby mode, press the soft key on the base.
2) Press the soft key. You will hear the announcement "Record Memo Message" and
a confirmation tone.
3) Start your recording.
4) When you have finished, press the soft key to stop recording. The system returns
to standby.
• The voice memo messages are recorded as an incoming messages.
• When the answering system is full, appears on the display, and recording is
terminated.
You can record a conversation from the handset or the base (more than two seconds and
less than ten minutes).
1) During a conversation, press the soft key.
2) Press the soft key to select Call Record. Recording a Call appears on the display.
A confirmation tone that can be heard by both parties sounds during recording. Use the
same procedure to stop recording. Stop Recording appears.
To screen an incoming call, use the following steps:
RECORD
START
STOP
MENU
OK
From the base
1) After the answering system answers, the base speaker will let you hear the calls as the
machine records the message. To adjust the volume, press If you
set the answering system to off, you cannot screen a call.
volume up/ down.
FULL
[57]
To Next Page
Loading...
Need help?
General
