Unify OpenScape DECT Phone S5 Base - Connecting the Headset; Connecting the Usb Data Cable

80
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Getting started
Gigaset S850 / ALL UK en / A31008-XXXXX-XXXX-X-XX / starting.fm / 12/2/14
Setting the date and time
Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
¤ Press the display key Time
or, if the date and time have already been set:
¤ ... use to select Settings OK Date/
Time OK
The active cursor position flashes . . . change cursor position
with . . . switch between cursor positions with
Enter date:
¤ . . . enter the day, month and year in 8-digit format with ,
e.g. for 15/08/2014.
Enter time:
¤ . . . enter hours and minutes in 4-digit format with ,
e.g. for 07:15 .
To save settings:
¤ Press the display key Save. . . . the message Saved is shown in
the display and you hear a confirmation tone
Returning to idle status:
¤ Press and hold the End call key
The telephone is now ready for use.
Connecting the headset
¤ Connect the headset with 2.5 mm jack to the left side of the
handset .
For information on recommended headsets, see the relevant
product page at www.gigaset.com/s850
.
The headset volume corresponds with the setting for the receiver
volume ( p. 115).
Connecting the USB data cable
For data exchange between the handset and PC:
¤ Connect the USB data cable with micro-USB plug into the
USB socket at the bottom of the handset .
Connect the handset directly to the PC, not via a
USB hub.
Calls Time
Date/Time
Date:
15/08/2014
Time:
00:00
Back Save
1
1
1
1