Fixing problems 117
Possible cause 1:
If "Clear other layer" appears on the menu:
you tried to program a function or internal station number with LED on a key that
is already programmed on the second layer (for
example, external station num-
ber).
Possible reaction:
Confirm "Clear other layer" to save the station number/function.
Possible cause 2:
If "Clear LED support" appears on the menu:
you tried to program a station number without LED display or an external station
number on a key that already is already programmed with an internal phone
number with LED display.
Possible reactions:
Confirm "Clear LED support" to save the station number. The existing internal
station number remains on the other layer without LED display.
Contact partner in the case of problems
Contact your service personnel if a fault persists for more than five minutes, for
example.
To Next Page
Loading...
