Basic Configuration
3) Click the “Troubleshoot” button and select “Module Fault List” in the menu.
Figure 14: The Module Fault List
4) Select level of seriousness in the drop-down list for the code(s) for which you want to change
level.
Fault Log
The fault log is a centralized log file and shows a complete log of the faults in the system. Every
time a fault message is generated in the system, information about the fault is written to the log
file. The maximum number of entries in the log file is 1050. When the log file is full, the 50 oldest
entries are removed.
1) Click “Configuration” on the Start page.
2) Select Status > Fault Log in the menu on the Configuration page.
The first 25 log entries are shown. To get the following 25 log entries, click the “Next” link.
The following fault levels exist in the log:
• Information
• Individual reset
• All OK
• Critical error
• Error
• Warning
A31003-M2000-M105-01-76A9, 29/06/2020
24 Wireless Service Gateway WSG, Administrator Documentation
To Next Page
Need help?
General