EasyManuals Logo

Unify Wireless Service Gateway WSG Administrator Documentation

Unify Wireless Service Gateway WSG
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
Additional System Settings
3) Under Common, click “Network” in the menu on the Advanced Configuration page
Figure 36: The Network Page
4) The following parameters can be set (some of these parameters can also be set in the setup
wizard):
Require network connection – Controls if the module needs a connection to the network to
start up. This can be useful if you want configure the module before connecting it to a net-
work.
DHCP – Controls whether static or dynamic IP address shall be assigned to this Elise
module. If DHCP is enabled, only the host name below is applicable.
IP address – Sets the IP address for the module
Default gateway – Sets the IP address to a Gateway on the LAN
Subnet mask – sets the network mask that is to be used. If this parameter is set to 0.0.0.0
it means that the Gateway never will be used.
Host name
Domain name – Sets the desired domain name for the module
DNS Server – Sets the IP address to a DNS if one exists. If no DNS Server is present on
the network, set this parameter to 0.0.0.0.
WINS Server – sets the IP address to a Primary WINS Server if one exists.
If no WINS Server is present on the network, set this parameter to 0.0.0.0.
5) Click “Activate”.
A31003-M2000-M105-01-76A9, 29/06/2020
Wireless Service Gateway WSG, Administrator Documentation 67

Table of Contents

Other manuals for Unify Wireless Service Gateway WSG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unify Wireless Service Gateway WSG and is the answer not in the manual?

Unify Wireless Service Gateway WSG Specifications

General IconGeneral
BrandUnify
ModelWireless Service Gateway WSG
CategoryTelephone
LanguageEnglish

Related product manuals