Unilumin Upad III User Manual

UpadIII product manual
www.unilumin.cn 26
In the Enable/Disable Calibration, select ”Brightness” then Click “Manage Coefficients”,
as in following fig:
Fig 3-16【Manage Coefficients】
Upload coefficients: Upload calibration coefficients to the LED display hardware.
Save coefficients to database: Read back the calibration coefficients from LED display
and then save it.
Set coefficients for a new Receiving Card: Upload calibration coefficients to a new
replaced receiving card.
Set coefficients for a new module: Upload right calibration coefficients to a new replaced
LED Module.
Adjust Coefficients: Fine tune the calibration coefficients for better performance.
Erase or reload Coefficients: Erase or reload the calibration coefficients on selected
section of LED display.
Reset Calibration Coefficients: Reset the calibration coefficients on whole or selected
section of LED display.

Unilumin Upad III Specifications

General

Brand	Unilumin
Model	Upad III
Category	Monitor
Language	English