UpadIII product manual
www.unilumin.cn III
For indoor products, in order to use display correctly, please read the
following carefully.
WARNING!
The device may get damaged or lead to unrecovered while ignoring the warning.
1) Prohibit throwing or turning upside down when moving and storing.
2) Prohibit scratching and physical collision during installation.
3) Prohibit being exposed to dripping or splashing.
4) Prohibit putting display under air-condition outlet directly.
5) Prohibit putting it under volatile, corrosive, flammable chemicals environment.
6) Prohibit using the product in rainy outdoor and/or above 80% humidity environment.
7) Prohibit using water or chemical solvent to clean the equipments.
8) Prohibit using non-certified electrical equipments.
9) Make sure the display and its accessory devices connect earth wire.
10) When accident, such as abnormal smell, smoke, leakage, temperature rising, please shut
down the power immediately and contact with qualified person.
CAUTION!
Display is not able to work in best condition while ignoring the cautions.
1) Wearing gloves and static wrist strap during installation or doing maintenance.
2) When designing heat dissipation system, taking ventilation of the back of the display into
consideration.
3) Keep humidity under 80% when storage.
4) Use single phase power when the Max capacity less or equal than 3KW, otherwise should
be three phase power.
5) Make sure to use the display twice a week , each time over two hours’ light-up.
6) Display may be much more likely to fail and has shorter lifespan when installed at seaside,
saline, sulfur-containing gases zone, kitchen exhaust or some area which has a high
temperature difference between outside and inside. If inevitable, please contact with our
service network for professional advice.
To Next Page
Loading...
Need help?
General
