Unilumin Upad III User Manual

UpadIII product manual
www.unilumin.cn 33
1） Prestore Picture Settings
Select Picture: Browse and choose the Prestore Pitcure.
Screen Effect: The selected picture will be stretched, tiled or centered to the whole
display.
Cabinet Effect: The selected picture will be stretched, tiled or centered to each cabinet of
the display (The number of picture each cabinet will show is the same as the number of
single-cabinet internal receiving card).
Click "Test Effect", show the selected picture on the display.
Click "Save to Hardware", save prestore picture settings to the hardware.
Check "Store Picture", check the effect of stored picture on the LED display.
2） Function Settings
Boot Screen: Set up the display time of Prestore Picture when the screen boot up.
Cable Disconnect: Set the display output when cable disconnect.
No DVI Signal: Set up the display output when no DVI signal.
Click "Send", send function settings to the hardware. (If no save to hardware, the settings
will lost after power off.)
Click "Save to Hardware", save Function Settings to the hardware. (the settings will not
lost after power off)

Unilumin Upad III Specifications

General

Brand	Unilumin
Model	Upad III
Category	Monitor
Language	English