-22- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
3.2.10 User-Programmable Supplementals
If you selected a Supplemental User-Programmable option, scan
User-Programmable Supplemental 1, and then scan three bar codes from
Appendix B, Numeric Bar Codes to set the 3-digit prefix.
To set a second 3-digit prefix, scan User-Programmable Supplemental 2,
and then scan three bar codes from Appendix B, Numeric Bar Codes. The
default is 000 (zeroes).
User-Programmable Supplemental 1
User-Programmable Supplemental 2
3.2.11 UPC/EAN/JAN Supplemental
Redundancy
If you selected Autodiscriminate UPC/EAN/JAN with Supplementals, this
option sets the number of times to decode a symbol without supplementals
before transmission. The range is from 2 to 16. Five or above is
recommended when decoding a mix of UPC/EAN/JAN symbols with and
without supplementals. The default is 10. To set a redundancy value, scan
the following bar code, and then scan two bar codes from Appendix B,
Numeric Bar Codes. Enter a leading zero for single digit numbers. To
correct an error or change a selection, scan Cancel.
UPC/EAN/JAN Supplemental Redundancy
To Next Page
Loading...
Need help?
General
