- 92 -
MS926 User’s Manual
4.7.4 Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Charts) for the single character code
that identifies each symbology. This action first clears all current prefixes, then
programs a Code I.D. prefix for all symbologies. This is a temporary setting
that will be removed when the unit is power cycled.
Add Code I.D. Prefix toAll Symbologies (Temporary)
Show Data Format
Scan the bar code below to show current data format settings.
Data Format Settings
To Next Page
Loading...
