Unitech MS926 - Code 128 Message Length

- 40 -
MS926 User’s Manual
3.3.9.4 Code 128 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
bar code being scanned was created using a code page that is different from
the one the host program is expecting. If this is the case, scan the bar code
below, select the code page with which the bar codes were created (see ISO
2022/ISO 646 Character Replacements), and scan the value and the Save bar
code from the Programming Chart. The data characters should then appear
properly.
Code 128 Code Page
3.3.10 UPC-A
Code UPC-A On*
Default All UPC-A Settings
Code UPC-A Off
Note: To convert UPC-A bar codes to EAN-13, see Convert UPC-A to EAN-13.
3.3.10.1 UPC-A Check Digit
This selection allows you to specify whether the check digit should be
transmitted at the end of the scanned data or not. Default = On.
On*
Off