Unitech MS926 - Bt Spp

- 21 -
MS926 User’s Manual
2.4 BT SPP (Slave)
BT SPP (Slave)
Establishing BT connection in BT SPP (Slave) mode.
1. To establish a BT connection between MS926 and your PC in BT SPP
(Slave) mode, you must install unitech CDC Driver on your PC in advance.
( For CDC driver, please check on the product section on unitech website : http://www.ute.com )
2. Use MS926 to scan BT SPP (Slave) barcode.
3. Press Page Down key then press Scan button to enter BT pairing mode.
4. Double-click Bluetooth Device icon in the toolbar on your PC. Select
Add New Devices. When you see a device list windows, choose
MS926-XXXX and then press Next.
5. When PC is establishing a BT connection in BT SPP (Slave) mode with
MS926, windows system will automatically install the required drivers.
6. Back to your PC toolbar, right click on the Bluetooth Device icon ,
choose Open Settings. Go to COM Port page and select out-going COM
port; for example COM 27.
7. MS926 will beep when your PC successfully establish a BT connection with
MS926.