- 22 -
MS926 User’s Manual
2.5 USB SPP
USB SPP
Establishing connection in USB SPP mode.
1. To establish connection between MS926 and your PC in USB SPP mode,
you must install unitech CDC Driver on your PC in advance.
( For CDC driver, please check on the product section on unitech website : http://www.ute.com )
2. Use MS926 to scan USB SPP barcode.
3. Connect MS926 to your PC with a Micro USB-USB cable.
4. Go to PC device manager to check the COM information, for example; CDC
USB Demonstration (COM40).
5. Back to the application, and select the corresponding COM port number.
MS926 will beep when your pc successfully establish the connection with
MS926.
To Next Page
Loading...
