Unitech MS926 - Chapter 2 - Installation; NFC Pairing with Mobile Devices; Bt Hid

- 20 -
MS926 User’s Manual
2.3 BT SPP
BT SPP
Establishing BT connection in BT SPP mode.
1. To establish BT connection between MS926 and your PC in BT SPP mode,
you must install unitech CDC driver on your PC in advance.
( For CDC driver, please check on the product section on unitech website : http://www.ute.com )
2. Use MS926 to scan BT SPP barcode.
3. Press Page Down key then press Scan button to enter BT pairing mode.
4. Double-click Bluetooth Device icon in the toolbar on your PC. Select
Add New Devices. When you see a device list windows, choose
MS926-XXXX and then press Next..
5. When PC is establishing a BT connection in BT SPP mode with MS926,
windows system will automatically install the required drivers.
6. Back to your PC toolbar, right click on the Bluetooth Device icon
,
choose Open Settings. Go to COM Port page and select in-coming COM
port ;for example COM 28.
7. MS926 will beep when your PC successfully establish a BT connection with
MS926.