Unitech MS926 - Code 39 Code Page; Interleaved 2 of

- 32 -
MS926 User’s Manual
3.3.3.1 Check digit
No Check Digit indicates that the scanner reads and transmits bar code data
with or without a check digit. When Check Digit is set to Validate, but Don’t
Transmit, the unit only reads Interleaved 2 of 5 bar codes printed with a check
digit, but will not transmit the check digit with the scanned data. When Check
Digit is set to Validate and Transmit, the scanner only reads Interleaved 2 of 5
bar codes printed with a check digit, and will transmit this digit at the end of the
scanned data. Default = No Check Digit.
No Check Digit*
Validate , but Don’t Transmit
Validate and Transmit
3.3.3.2 Interleaved 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description for additional information.
Minimum and Maximum lengths = 2-80.
Minimum Default = 4, Maximum Default = 80.
Minimum Message Length
Maximum Message Length