- 31 -
MS926 User’s Manual
3.3.2.6 Code 39 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
bar code being scanned was created using a code page that is different from
the one the host program is expecting. If this is the case, scan the bar code
below, select the code page with which the bar codes were created (see ISO
2022/ISO 646 Character Replacements), and scan the value and the Save bar
code from the Programming Chart. The data characters should then appear
properly.
Code 39 Code Page
3.3.3 Interleaved 2 of 5
Interleaved 2 of 5 On*
Default All Interleaved 2 of 5 Settings
Interleaved 2 of 5 Off
To Next Page
Loading...
