Unitech MS926 - Add a Data Format

- 95 -
MS926 User’s Manual
Enter Data Format Discard
Save
4.8.3 Other Programming Selections
Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan 0 from the Programming Chart. If you are clearing an alternate
format, scan 1,2, or 3, depending on the format you are clearing. Scan
the Terminal Type and Code I.D. (see Symbology Charts ),
and the bar code data length for the specific data format that you want to
delete. All other formats remain unaffected.
Clear all Data Formats This clears all data formats.
Save to exit and save your data format changes.
Discard to exit without saving any data format changes.
Clear One Data Format
Clear All Data Formats
Save
Discard