- 77 -
MS926 User’s Manual
4.6 Scan mode / Parameter Selection
4.6.1 Manual Trigger Mode
When in manual trigger mode, the scanner scans until a bar code is read, or
until the trigger is released.
4.6.1.1 LED Illumination - Manual Trigger
If you wish to set the illumination LED brightness, scan one of the bar codes
below. This sets the LED illumination for the scan engine when the trigger is
pressed. Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scan engine can “see” the bar codes.
High*
Medium
Low
Manual Trigger - Normal
To Next Page
Loading...
