Controls:
The ULS Computer Controlled Compressed Air Unit functions automatically when connected the laser system
and no operator intervention is necessary. Controls and indicators on the unit are for diagnostics and provide
the following information:
Link light – blinks to indicate good communications link with the laser system
ON and OFF lights – indicate the state of the compressor. If the ON light is illuminated the compressor
should be running and supplying compressed air. If the OFF light is illuminated the compressor should be
off and no compressed air is being supplied.
Manual ON/OFF switch – turns compressor on or off manually to verify operation.
Maintenance
The particle filter should be inspected every 8 to 16 hours of use. Clean out the filter as necessary. The filter can
be inspected by unscrewing the lower bell shaped portion of the filter housing (1/8 turn) and removing the red
foam filter found inside. If it needs cleaning, wash it in water, dry it thoroughly and reassemble.
89
Air
Compressor Gas
CONTROL
WIRE
Computer Controlled
Air Assist
BLUE COILED HOSE
FILTER
FITTING
OFF
BLUE COILED HOSE
LINK
INPUT
POWER
ON
MANUAL
ON/OFF
SWITCH
COMMUNICATION
PORT
To Next Page
Loading...
