Universal Radial 8 - Changes to this Revision

To Previous Page

Page 25
Radial 8 & 88 Operation Reference Manual 49379902 Rev. G
This Document Supports IM-UPS 5.0 and Higher
Changes To This Revision
On p. 11, added description of audible alarm volume control on light tower.
On p. 22, revised descriptions for Alternate Feeder and Feeder Priming.

Main Page

Table of Contents2
Introduction3
Straight Back Sequencer Configuration3
In-Line Sequencer Configuration3
Intended Audience4
Safety Considerations4
Lockout/Tagout Procedure4
Functional Description4
Insertion Machine Assemblies6
Conventions Used in this Manual9
Machine Push Button Control Panel10
Emergency-Stop Switch (E-Stop)10
Repair10
STOP Push Button11
START Push Button11
OVERRIDE / TRANSFER ERROR Push Button/Indicator11
INTLK RESET Push Button/Indicator12
OPERATING MODE Key Switch12
Expanded Range Verifier (ERV) Test Port13
Machine Light Tower13
Power Chassis Assembly14
Function of Power Chassis Fuses14
I/O Box Assembly15
MMIT mit Board (Slot 1)15
Multi-Input Boards (Slots 3 and 4)15
DC Output Board (Slot 6)15
Board Error Correction (BEC) Board (Slot 11)15
Board Handling (Slots 8 and 9)16
Service Disconnect16
Electrical Lockout / Tagout16
Toggle Valve Assembly16
Sequencer Controls and Indicators17
Emergency Stop Switch (E-Stop)17
Interlock18
STOP Push Button18
START Push Button19
Sequencer LED Indicators19
Sequencer Fuse Panel19
Function of Sequencer Fuse Panel Fuses19
Pneumatic Controls and Indicators20
Lockout Valve20
Pneumatic Lockout / Tagout20
Machine Configuration20
Machine Operation25
Dry Cycle25
Defragment the Hard Disk26
Changes to this Revision27

Universal Radial 8 - Changes to this Revision

Table of Contents