EasyManuals Logo
Home>Upright>Lifting Systems>TM12

Upright TM12 Service Manual

Upright TM12
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
107098-002 TM12 - Operator Manual Page 1
O
PERATOR
M
ANUAL
WARNING
All personnel shall carefully read, understand and follow all safety rules, operating instructions,
and the Scaffold Industry Association’s MANUAL OF RESPONSIBILITIES of ANSI A92.6-1999
before performing maintenance on or operating any UpRight Aerial Work Platform.
Safety Rules
Safety RulesSafety Rules
Safety Rules
NEVER
operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps,
curbs, or debris.
NEVER
operate the machine if all guardrails are not properly in place and secured with all fasteners properly torqued.
ALWAYS
close and secure the entrance after entering the platform.
NEVER
use ladders or scaffolding on the platform.
NEVER
exceed the maximum platform load. See “Specifications” on page 16.
NEVER
attach overhanging loads or increase platform size.
LOOK
up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE
all platform loads evenly on the platform.
NEVER
use damaged equipment. (Contact UpRight for instructions. See toll free phone number on inside back cover.)
NEVER
change operating or safety systems.
INSPECT
the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, damaged cables or
hoses, loose wire connections, and wheel bolts.
NEVER
climb down elevating assembly when the platform is elevated.
IF ALARM SOUNDS
while the platform is elevated, STOP, carefully lower the platform. Move the machine to a firm, level
surface.
IN CASE OF EMERGENCY
push the Emergency Stop Switch to cut power to all machine functions.
NEVER
perform service on the machine while the platform is elevated without blocking the elevating assembly.
NEVER
recharge batteries near sparks or open flame; batteries that are being charged emit explosive hydrogen gas.
NEVER
replace any component or part with anything other than original UpRight replacement parts without the manufac-
turer’s written consent.
VERIFY
that all labels are in place and legible before using.
NEVER
tow the machine. Transport by truck or trailer only.
AFTER USE
, secure the machine against unauthorized use by turning the Chassis Key Switch off and removing the key.
California Proposition 65 Warning
Battery Posts, terminals and related accessories contain lead compounds, chemicals known to the State of
California to cause cancer and reproductive harm. Wash hands after handling.
NEVER operate or drive with the
platform elevated unless on firm, level
surface.
NEVER position the machine without
first checking for overhead obstructions
or other hazards.
NEVER climb, stand or sit on the
platform guardrails or midrail.
Electrocution Hazard
Electrocution HazardElectrocution Hazard
Electrocution Hazard Tip Over Hazard
Tip Over HazardTip Over Hazard
Tip Over Hazard Collision Hazard
Collision HazardCollision Hazard
Collision Hazard Fall Hazard
Fall HazardFall Hazard
Fall Hazard
NEVER operate the machine within ten
(10) feet of power lines.
THIS MACHINE IS NOT INSULATED.

Table of Contents

Other manuals for Upright TM12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Upright TM12 and is the answer not in the manual?

Upright TM12 Specifications

General IconGeneral
BrandUpright
ModelTM12
CategoryLifting Systems
LanguageEnglish

Related product manuals