DS1093-520 56
• Reboot IPC: Reboot the IP Camera (IP Camera with ONVIF Protocol cannot be rebooted).
IMPORTANT NOTE:
It is strongly recommended to Backup the record files stored in the Hard Disk before Upgrade Firmware
Version. After Backup Process, the files shall be played using the Player Software present in the old
Firmware Release.
After Uploading Default Settings please set again the Basic Configurations (i.e. Video Out Control,
Language, Date/Time and Record Parameters, etc.)
3.8.2 EVENTS
The DVR can activate various types of notifications following system events. This page can be used to configure them.
• Event Type: this can be used to select the event to be configured, support the three abnormal types: Disk No Space,
Disk Error and Video Loss.
• Enable: this can be used to enable or disable sending notifications in case of the selected event..
• Show message: You can set show the icon on the screen when the event is detected. About icons type please refer
to Section 4.
• Send Email: if selected, a notification email is sent to the configured addresses (see paragraph 3.4.4.2 – “Email set”
for details)..
• Buzzer: you can set how long the buzzer will sound when the event is detected, available values: OFF, 10sec, 20sec,
40sec, 60sec
Event Type Function
HDD No Space
When Hard Drive is not detected (HDD damage, power supply malfunction), or HDD auto-overwrite
is off, and free space is not enough, an alarm will be triggered.
Video Loss
Sends alarm when DVR can’t receive video signal (such as camera damage, cable broken or
damaged or power supply malfunction).
To Next Page
Loading...
Need help?
General
