DS1093-520 60
3.10.8 CRUISE SET
Open auto cruise function on PTZ setting menu if you want to setup cruise function (system default: off), and set up cruise
channel, cur point and total quantity and stop time etc
How to set pre-set point
• Total: set up pre-set point quantity
• Cur Point: indicates starting point cruised. System default point is 01. The model support up to 255 pre-set points.
• Time: sets the stop time at each point
• CALL: allow you go to a specific preset point.
• SET: allow you set a set of specific preset points of a PTZ camera.
Note:
Use 95 to enter the OSD menu of the Speedome. Run the SET95 control if CALL95 does not work. See the
Speedome manual for the Speedome OSD.
1. Select a camera you desire to set a preset point;
2. Adjust the camera in a desired direction;
3. Click [Set] to set the point as preset point;
4. Click [Save] to save the preset point;
5. Follow the above step to add one more preset point.
• Save: save all the preset points
• Clear: allow you delete one selected preset point.
Note: Up to 254 pre-sets per one camera can be stored. However, actual preset quantity differs depending on PTZ
performance.
To Next Page
Loading...
Need help?
General
