D. Plug the AC power adapter into the 9VDC jack on the back of your gateway. Then plug the
AC power adapter into a standard wall outlet. If the LED on the front panel is not lighted,
press the power switch on the back of the gateway.
The gateway starts up after you turn on the power. This may take one to two minutes.
E. On the front panel, see if the and any of the indicators LEDs are lighted. If they
are not, see the troubleshooting section
.
Step 3. Install EasyConfigurator
1. Insert the U.S. Robotics installation CD-ROM into your computer CD-ROM drive. The
installation should start automatically. This process may take a few moments.
If the installation does not start automatically, you can start it manually.
Windows users: Click Start and then Run, then type D:\setup.exe in the dialogue
box and click OK. (If your CD drive uses a different letter, type that letter in place of
D.)
Macintosh users: Open the CD-ROM and double click on either MacOS X Install or
MacOS Classic Install (depending on which operating system your computer uses).
Linux users: Open the CD-ROM, browse to \platforms\linux, and double-click on
install.bin.
2. Select your preferred language and click OK.
3. If you are using Windows, the installer runs a qualification test to verify that your
system meets the minimum requirements for installation. When done, a Results
screen displays green flags next to system components that meet requirements and
red flags next to any that do not. If your system passes the qualification, click Next. If
any of your system components do not meet the requirements, click View Report to
identify them.
Setup now installs the EasyConfigurator.
Step 4. Configure the Gateway with EasyConfigurator
1. This is the EasyConfigurator login window:
第 3 頁，共 7 頁U.S. Robotics Wireless MAXg ADSL Gateway User Guide
2005/7/4file://C:\Documents%20and%20Settings\ivonne\Local%20Settings\Temp\Rar$EX48.000\insta...
To Next Page
Loading...
