Utax 5240L

8-144
Default Setting (System Menu)
LDAP Security
Specify the protocol to be used for LDAP. The default setting is Off.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the U or V key to
select [System], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
5 Press the U or V key to select [Secure Protocol].
6 Press the OK key. Secure Protocol appears.
7 Press the U or V key to select [LDAP Security].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
8 Host Name
9 LAN Interface
[ Exit ]
7 Secure Protocol
Secure Protocol: a b
2 IPP Security
3 HTTP Security
*********************
[ Exit ]
4 LDAP Security