Default Setting (System Menu)
8-144 OPERATION GUIDE
IPSec Setting
Make this setting when you use IPSec. The default setting is On and that of Rule Setting is also Off.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [IPSec].
6 Press the OK key. IPSec appears.
7 Press the U or V key to select [On] or [Off].
Sys. Menu/Count.:
a
b
1
Report
2
Counter
*********************
[ Exit ]
Login User Name:
L
b
*******************
Login Password:
[ Menu ] [ Login ]
System:
a
b
*********************
2
I/F Block Set.
3
Security Level
[ Exit ]
Network Setting:
a
b
4
WSD-SCAN
5
WSD-PRINT
*********************
[ Exit ]
IPSec:
a
b
*********************
2
On
To Next Page
Loading...